Ospfv3; Ospfv3 Area - H3C MSR 20-20 Command Reference Manual

ospfv3

Syntax
View
Parameters
Description
Related commands:
Examples

ospfv3 area

Syntax
View
Parameters
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] maximum load-balancing 6
ospfv3 [ process-id ]
undo ospfv3 [ process-id ]
System view
process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535. The
process ID defaults to 1.
Use the
ospfv3
Use the undo ospfv3
The system runs no OSPFv3 process by default.
router-id.
n
An OSPFv3 process can run normally only when Router ID is configured in OSPFv3
view. Otherwise, you can find the process, but which cannot generate any LSA.
# Enable the OSPFv3 process with process ID as 120 and configure the Router ID
as 1.1.1.1.
<Sysname> system-view
[Sysname] ospfv3 120
[Sysname-ospfv3-120] router-id 1.1.1.1
ospfv3 process-id area area-id [ instance instance-id ]
undo ospfv3 process-id area area-id [ instance instance-id ]
Interface view
process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.
area-id: The ID of an area, a decimal integer (in the range of 0 to 4294967295)
that is translated into IPv4 address format by the system or an IPv4 address.
instance-id: The instance ID of an interface, in the range of 0 to 255, which
defaults to 0.
command to enable an OSPFv3 process and enter OSPFv3 view.
command to disable an OSPFv3 process.
1299