Display Rip Interface; Display Rip Route - H3C MSR 20-20 Command Reference Manual

display rip interface

Syntax
View
Parameters
Description
Examples

display rip route

Syntax
View
Parameters
display rip process-id interface [ interface-type interface-number ]
Any view
process-id: RIP process number, in the range of 1 to 65535.
interface-type interface-number: Specifies an interface.
Use the
display rip interface
of the RIP process.
If no interface is specified, information about all RIP interfaces of the RIP process is
displayed.
# Display all the interface information of RIP process 1.
<Sysname> display rip 1 interface
Interface-name: Ethernet1/0
Address/Mask:1.1.1.1/24
Split-horizon/Poison-reverse:on/off
Current packets number/Maximum packets number: 234/2000
Table 280 Description on the fields of the display rip interface command
Field
Interface-name
Address/Mask
MetricIn/Out
Version
Split-horizon
Poison-reverse
Input/Output
Current packets
number/Maximum packets
number
display rip process-id route [ statistics | ip-address { mask | mask-length } | peer
ip-address ]
Any view
process-id: RIP process number, in the range of 1 to 65535.
command to display the RIP interface information
MetricIn/Out:0/1
Description
The name of an interface running RIP.
The IP address and Mask of the interface.
Additional routing metric added to the incoming and outgoing
routes
RIP version running on the interface
Indicates whether the split-horizon is enabled (ON: enabled, OFF:
disabled).
Indicates whether the poison-reverse is enabled (ON: enabled,
OFF: disabled)
Indicates if the interface is allowed to receiving (Input) or sending
(Output) RIP messages (on is allowed, off is not allowed).
Packets to be sent/Maximum packets that can be sent on the
interface
Version: RIPv1
Input/Output:on/on
1165