Apply Isis - H3C MSR 20-20 Command Reference Manual

Description
Examples

apply isis

View
Parameters
Description
Related commands:
Examples
additive: Adds to the original community attribute of a route.
Use the
apply extcommunity
community attribute to BGP routes.
Use the
undo apply extcommunity
configuration.
No extended community attribute is set for routing information by default.
# Create routing policy policy1 with node 10, matching mode as permit. If a BGP
route matches AS-path-ACL 1, add the RT extended community attribute 100:2 to
the route.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply extcommunity rt 100:2 additive
apply isis { level-1 | level-1-2 | level-2 }
undo apply isis
Routing policy view
level-1: Redistributes routes into IS-IS level-1 area.
level-2: Redistributes routes into IS-IS level-2 area.
level-1-2: Redistributes routes into IS-IS level-1 and level-2 areas.
Use the command to redistribute routes into a specified ISIS level.
apply isis
Use the
undo apply isis
No level is set by default.
if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,
if-match cost, if-match tag, route-policy, apply cost, apply origin and apply
tag.
# Create routing policy policy1 with node 10, matching mode as permit. If a route
matches tag 8, redistribute the route to IS-IS level-2 area.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match tag 8
[Sysname-route-policy] apply isis level-2
command to apply the specified extended
command to remove the clause
command to remove the clause configuration.
1191