Peer Connect-Interface (Ipv6 Address Family View) - H3C MSR 20-20 Command Reference Manual

1246 C 82: IP 6 BGP C
HAPTER V
Parameters
Description
Examples

peer connect-interface (IPv6 address family view)

Syntax
View
Parameters
Description
Examples
C
ONFIGURATION OMMANDS
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
Use the
peer capability-advertise route-refresh
BGP route-refresh.
Use the undo peer capability-advertise route-refresh
the function.
By default, route-refresh is enabled.
# Disable route-refresh of peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 as-number 100
[Sysname-bgp-af-ipv6] undo peer 1:2::3:4 capability-advertise route-refresh
peer { ipv6-group-name | ipv6-address } connect-interface interface-type
interface-number
undo peer { ipv6-group-name | ipv6-address } connect-interface
IPv6 address family view
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
interface-type interface-number: Specifies the type and name of the interface.
Use the
peer connect-interface
establishing TCP connections to an IPv6 BGP peer or peer group.
Use the
undo peer connect-interface
By default, BGP uses the outbound interface of the best route to the IPv6 BGP
peer/peer group as the source interface for establishing a TCP connection.
Note that:
To establish multiple BGP connections to a BGP router, you need to specify on the
local router the respective source interfaces for establishing TCP connections to
the peers on the peering BGP router; otherwise, the local BGP router may fail to
establish TCP connections to the peers when using the outbound interfaces of the
best routes as the source interfaces.
# Specify loopback0 as the source interface for routing updates to peer 1:2::3:4.
command to enable IPv6
command to specify the source interface for
command to restore the default.
command to disable