Idle-Cut; Ip Pool - H3C MSR 20-20 Command Reference Manual

1938 C 127: AAA C
HAPTER

idle-cut

Syntax
View
Parameter
Description
Related command:
Example

ip pool

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
idle-cut { disable | enable minute }
ISP domain view
disable: Disables the idle cut function.
enable minute: Enables the idle cut function. The minute argument refers to the
allowed idle duration, in the range 1 to 120 minutes.
Use the command to enable or disable the idle cut function.
idle-cut
By default, the function is disabled.
domain.
# Enable the idle cut function and set the idle threshold to 50 minutes for ISP
domain aabbcc.net.
<Sysname> system-view
[Sysname] domain aabbcc.net
[Sysname-isp-aabbcc.net] idle-cut enable 50
ip pool pool-number low-ip-address [ high-ip-address ]
undo ip pool pool-number
System view, ISP domain view
pool-number: Address pool number, in the range 0 to 99.
low-ip-address and high-ip-address: Start and end IP addresses of the address
pool. Up to 1024 addresses are allowed for an address pool. If you do not specify
the end IP address, there will be only one IP address in the pool, namely the start IP
address.
Use the command to configure an address pool for assigning addresses to
ip pool
PPP users.
Use the
undo ip pool
By default, no IP address pool is configured for PPP users.
Configure an IP address pool in system view and use the remote address
■
command in interface view to assign IP addresses from the pool to PPP users.
command to delete an address pool.