Display Ospf Mpls-Te - H3C MSR 20-20 Command Reference Manual

display ospf mpls-te

Syntax
View
Parameter
Description
Example
Table 417 Description on the fields of display mpls te tunnel-interface command
Field
BackUpBW Flag
BackUpBW Type
BackUpBW
Route Pinning
Retry Limit
Retry Interval
Reopt
Reopt Freq
Back Up Type
Back Up LSPID
Auto BW
Auto BW Freq
Min BW
Max BW
Current Collected BW
Interfaces Protected
VPN Bind Type
VPN Bind Value
Car Policy
display ospf [ process-id ] mpls-te [ area area-id ] [ self-originated ]
Any view
process-id: OSPF process ID, in the range 1 to 65535. If a process is specified, only
the TE LSAs of this process are displayed; if no process is specified, the TE LSAs of
all processes are displayed.
area area-id: Displays the TE LSAs of a specified OSPF area. The area-id argument
takes an integer in the range 0 to 4294967295 or the form of IPv4 address.
self-originated: Displays self originated TE LSAs.
Use the display ospf mpls-te
database (LSDB).
# Display all TE LSAs in the LSDB.
<Sysname> display ospf mpls-te
OSPF Process 100 with Router ID 10.0.0.1
Area ID:
Traffic Engineering LSA's of the database
------------------------------------------------
Description
Backup bandwidth flag
Backup bandwidth type
Backup bandwidth
Route pinning function
Maximum number of setup retries
Retry interval
State of the reoptimization function
Reoptimization interval
Backup path type
Backup LSP ID
State of the automatic bandwidth adjustment function
Automatic bandwidth adjustment interval
Lower limit for automatic bandwidth adjustment
Upper limit for automatic bandwidth adjustment
Bandwidth information currently collected
FRR protected interfaces
Type of the binding, VPN or ACL
Value of the binding, the VPN instance name or ACL
number
Whether CAR policy is enabled
command to display TE LSAs in the link state
1599