Enable Link-Local-Signaling; Enable Log - H3C MSR 20-20 Command Reference Manual

1130 C 76: OSPF C
HAPTER

enable link-local-signaling

Syntax
View
Parameters
Description
Examples

enable log

Syntax
View
Parameters
Description
C
ONFIGURATION OMMANDS
Table 277 Description on the fields of the display ospf vlink command
Field
Cost
State
Type
Transit Area
Timers
enable link-local-signaling
undo enable link-local-signaling
OSPF view
None
Use the
enable link-local-signaling
signaling (LLC) capability.
Use the
undo enable link-local-signaling
link-local signaling capability.
By default, this capability is disabled.
# Enable link-local signaling for OSPF process 1.
<Sysname> system-view
[Sysname] ospf 1
[Sysname-ospf-1] enable link-local-signaling
enable log [ config | error | state ]
undo enable log [ config | error | state ]
OSPF view
config: Enables configuration logging.
error: Enables error logging.
state: Enables state logging.
Use the enable command to enable specified OSPF logging.
Description
Interface route cost
Interface state
Type: virtual link
Transit area ID if the interface attached to a virtual link
Values of timers: Hello, Dead, Poll (NBMA), Retransmit, and
Interface transmit delay
command to enable the OSPF link-local
command to disable the OSPF