Ospfv3 Timer Retransmit; Ospfv3 Trans-Delay - H3C MSR 20-20 Command Reference Manual

Related commands:
Examples

ospfv3 timer retransmit

Syntax
View
Parameters
Description
Examples

ospfv3 trans-delay

Syntax
View
ospfv3 timer dead.
# Configure the hello interval as 20 seconds for an interface of instance 1.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ospfv3 timer hello 20 instance 1
ospfv3 timer retransmit interval [ instance instance-id ]
undo ospfv3 timer retransmit [ instance instance-id ]
Interface view
interval: Specifies LSA retransmission interval in seconds for an interface, ranging
from 1 to 65535.
instance-id: The instance ID of an interface, in the range of 0 to 255, which
defaults to 0.
Use the ospfv3 timer retransmit
retransmission interval for an interface of an instance.
Use the
undo ospfv3 timer retransmit
The interval defaults to 5 seconds.
When a router sends a LSA to its neighbor, it waits for an acknowledgement. If
receiving no acknowledgement after retransmission interval elapses, it will
retransmit the LSA.
The LSA retransmission interval should not be too small for avoidance of
unnecessary retransmissions.
# Configure the LSA retransmission interval on an interface of instance 1 as 12
seconds.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ospfv3 timer retransmit 12 instance 1
ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ instance instance-id ]
Interface view
command to configure the LSA
command to restore the default.
1303