H3C MSR 20-20 Command Reference Manual page 1326

1326 C 86: IP 6 S
HAPTER V TATIC
View
Parameters
Description
Related commands:
Examples
R C C
OUTING ONFIGURATION OMMANDS
undo ipv6 route-static ipv6-address prefix-length [ interface-type interface-number |
nexthop-address ] [ preference preference-value ]
System view
ipv6-address prefix-length: IPv6 address and prefix length.
interface-type interface-number: Interface type and interface number of the
output interface.
nexthop-address: Next hop IPv6 address.
preference-value: Route preference value, in the range of 1 to 255. The default is
60.
Use the
ipv6 route-static
Use the undo ipv6 route-static
An IPv6 static route that has the destination address configured as "::/0" (a prefix
length of 0) is the default IPv6 route. If the destination address of an IPv6 packet
does not match any entry in the routing table, this default route will be used to
forward the packet.
While configuring static routes, you can configure either the output interface or
the next-hop address depending on the situations:
If the output interface is a broadcast interface, such as an Ethernet interface, a
■
VLAN interface, or an NBMA interface (such as an interface with X25 or frame
relay encapsulated), then the next hop address must be specified;
If the output interface is a point-to-point interface, such as a serial port, you
■
can specify either the output interface or the next hop address, but not both.
display ipv6 routing-table on page 942 and delete ipv6 static-routes all.
# Configure a static IPv6 route, with the destination address being 1:1:2::/24 and
next hop being 1:1:3::1.
<Sysname> system-view
[Sysname] ipv6 route-static 1:1:2:: 24 1:1:3::1
command to configure an IPv6 static route.
command to remove an IPv6 static route.