1630
C
96: MPLS TE C
HAPTER
View
Parameter
Description
Example
mpls te reoptimization (user view)
Syntax
View
Parameter
Description
Example
mpls te reoptimization (tunnel interface view)
Syntax
View
Parameter
Description
C
ONFIGURATION
OMMANDS
Tunnel interface view
label: Includes the record of labels in the route record. This keyword is not
supported when the signaling protocol is CR-LDP. This keyword is not supported
when the signaling protocol is CR-LDP.
Use the
mpls te record-route
recording.
Use the
undo mpls te record-route
By default, route recording and label recording are disabled.
# Enable route recording on MPLS TE tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te record-route
mpls te reoptimization
User view
None
Use the
mpls te reoptimization
reoptimization-enabled TE tunnels.
# Start reoptimizing all reoptimization-enabled TE tunnels.
<Sysname> mpls te reoptimization
mpls te reoptimization [ frequency seconds ]
undo mpls te reoptimization
Tunnel interface view
seconds: Reoptimization frequency, in the range 1 to 604800 seconds. The default
is 3600 seconds, or 1 hour.
Use the
mpls te reoptimization
tunnel.
command to enable route recording or label
command to restore the default.
command to start reoptimizing all
command to enable reoptimization on the