Reset Dot1X Statistics - H3C MSR 20-20 Command Reference Manual

Related command:
Example

reset dot1x statistics

Syntax
View
Parameter
Description
response after sending the allowed maximum number of handshake requests,
it considers that the supplicant is offline.
Quiet timer (quiet-period): When a supplicant fails the authentication, the
■
authenticator refuses further authentication requests from the supplicant in
this period of time.
Server timeout timer (server-timeout): Once an authenticator sends a RADIUS
■
Access-Request packet to the authentication server, it starts this timer. If this
timer expires but it receives no response from the server, it retransmits the
request.
Supplicant timeout timer (supp-timeout): Once an authenticator sends an
■
EAP-Request/MD5 Challenge frame to a supplicant, it starts this timer. If this
timer expires but it receives no response from the supplicant, it retransmits the
request.
Username request timeout timer (tx-period): Once an authenticator sends an
■
EAP-Request/Identity frame to a supplicant, it starts this timer. If this timer
expires but it receives no response from the supplicant, it retransmits the
request. In addition, to be compatible with clients that do not send
EAPOL-Start requests unsolicitedly, the device multicasts EAP-Request/Identity
frame periodically to detect the clients, with the multicast interval defined by
tx-period.
Generally, it is unnecessary to change the timers unless in some special or extreme
network environments.
display dot1x.
# Set the server timeout timer to 150 seconds.
<Sysname> system-view
[Sysname] dot1x timer server-timeout 150
reset dot1x statistics [ interface interface-list ]
User view
interface interface-list: Specifies an Ethernet port list, which can contain multiple
Ethernet ports. The interface-list argument is in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] } &
<1-10>, where interface-type represents the port type, interface-number
represents the port number, and & <1-10> means that you can provide up to 10
port indexes/port index lists for this argument. The start port number must be
smaller than the end number and the two ports must of the same type.
Use the reset dot1x statistics command to clear 802.1x statistics.
1911