Figure 5.3 Relation Between Irq7 And Irq6 Interrupts, Kin15 To Kin0 Interrupts, Wue7 To Wue0 Interrupts, Kmimr, Kmimra, And Wuemrb (Extended Vector Mode: Eivs = 1) - Renesas H8S Series Hardware Manual

Section 5 Interrupt Controller
KMIMR0 (Initial value of 1)
P60/KIN0
KMIMR5 (Initial value of 1)
P65/KIN5
KMIMR6 (Initial value of 1)
P66/KIN6/IRQ6
P52/ExIRQ6
KMIMR7 (Initial value of 1)
P67/KIN7/IRQ7
P42/ExIRQ7
KMIMR8 (Initial value of 1)
PA0/KIN8
KMIMR15 (Initial value of 1)
PA7/KIN15
WUEMR0 (Initial value of 1)
PB0/WUE0
WUEMR7 (Initial value of 1)
PB7/WUE7
WUEMR8 (Initial value of 1)
PC0/WUE8
WUEMR15 (Initial value of 1)
PC7/WUE15
Note: The ISS7 bit is an external interrupt pin switch bit. For details, see section 5.3.8,
IRQ Sence Port Select Register 16 (ISSR16), IRQ Sense Port Select Register (ISSR).
Figure 5.3 Relation between IRQ7 and IRQ6 Interrupts, KIN15 to KIN0 Interrupts,
WUE7 to WUE0 Interrupts, KMIMR, KMIMRA, and WUEMRB
In extended vector mode, the initial value of the KMIMR6 bit is 1. Accordingly, it does not enable
of disable the IRQ6 pin interrupt. The interrupt input from the ExIRQ6 pin becomes the IRQ6
interrupt request.
Rev. 3.00 Jul. 14, 2005 Page 96 of 986
REJ09B0098-0300
ISS7
(Extended Vector Mode: EIVS = 1)
KIN internal
signal
Falling-edge
detection circuit
Edge-level selection
enable/disable
circuit
Edge-level selection
enable/disable
circuit
KINA internal
signal
Falling-edge
detection circuit
WUEB internal
signal
Falling-edge
detection circuit
WUE internal
signal
Falling-edge
detection circuit
KIN interrupt
(KIN7 to KIN0)
IRQ6 interrupt
IRQ7 interrupt
KINA interrupt
(KIN15 to KIN8)
WUEB interrupt
(WUE7 to WUE0)
WUE interrupt
(WUE15 to WUE8)