Switching Between User Mat And User Boot Mat; Figure 21.17 Switching Between User Mat And User Boot Mat - Renesas H8S Series Hardware Manual
16-bit single-chip microcomputer
Hide thumbs
Also See for H8S Series:
- Hardware manual (1047 pages) ,
- User manual (38 pages) ,
- Hardware manual (875 pages)
Table of Contents
Advertisement
21.6
Switching between User MAT and User Boot MAT
It is possible to switch between the user MAT and user boot MAT. However, the following
procedure is required because both of these MATs are allocated to address 0.
(Switching to the user boot MAT disables programming and erasing. Programming of the user
boot MAT should take place in boot mode or programmer mode.)
1. MAT switching by FMATS should always be executed from the on-chip RAM.
2. To ensure that switching has finished and access is made to the newly switched MAT, execute
four NOP instructions in the same on-chip RAM immediately after writing to FMATS (this
prevents access to the flash memory during MAT switching).
3. If an interrupt has occurred during switching, there is no guarantee of which memory MAT is
being accessed.
Always mask the maskable interrupts before switching between MATs. In addition, configure
the system so that NMI interrupts do not occur during MAT switching.
4. After the MATs have been switched, take care because the interrupt vector table will also have
been switched.
If interrupt handling is to be the same before and after MAT switching, transfer the interrupt
handling routines to the on-chip RAM and set the WEINTE bit in FCCS to place the interrupt-
vector table in the on-chip RAM.
5. Memory sizes of the user MAT and user boot MAT are different. Do not access a user boot
MAT in a space of 8 kbytes or more. If access goes beyond the 8-kbyte space, the values read
are undefined.
<User MAT>
Figure 21.17 Switching between User MAT and User Boot MAT
Section 21 Flash Memory (0.18-µm F-ZTAT Version)
<On-chip RAM>
Procedure for
switching to
user boot MAT
Procedure for
switching to
user MAT
Procedure for switching to user boot MAT:
1. Disable interrupts (mask).
2. Write H'AA to FMATS.
3. Execute four NOP instructions before accessing the user boot MAT.
Procedure for switching to user MAT:
1. Disable interrupts (mask).
2. Write a value other than H'AA to FMATS.
3. Execute four NOP instructions before accessing the user MAT.
<User boot MAT>
Rev. 3.00 Jul. 14, 2005 Page 795 of 986
REJ09B0098-0300
Advertisement
Table of Contents
