Renesas H8S Series Hardware Manual page 576

2
Section 16 I C Bus Interface (IIC)
Bit Bit Name Initial Value R/W
2 AAS 0
1 ADZ 0
Rev. 3.00 Jul. 14, 2005 Page 528 of 986
REJ09B0098-0300
Description
R/(W)* Slave Address Recognition Flag
2
In I C bus format slave receive mode, this flag is set to 1 if
the first frame following a start condition matches bits
SVA6 to SVA0 in SAR, or if the general call address (H'00)
is detected.
[Setting condition]
When the slave address or general call address (one
frame including a R/W bit is H'00) is detected in slave
receive mode and FS = 0 in SAR
[Clearing conditions]
•
When ICDR is written to (transmit mode) or read from
(receive mode)
•
When 0 is written in AAS after reading AAS = 1
•
In master mode
R/(W)* General Call Address Recognition Flag
2
In I C bus format slave receive mode, this flag is set to 1 if
the first frame following a start condition is the general call
address (H'00).
[Setting condition]
When the general call address (one frame including a R/W
bit is H'00) is detected in slave receive mode and FS = 0 or
FSX = 0
[Clearing conditions]
•
When ICDR is written to (transmit mode) or read from
(receive mode)
•
When 0 is written in ADZ after reading ADZ = 1
•
In master mode
If a general call address is detected while FS=1 and
FSX=0, the ADZ flag is set to 1; however, the general call
address is not recognized (AAS flag is not set to 1).