Renesas H8S Series Hardware Manual page 486

Section 15 Serial Communication Interface (SCI, IrDA)
• Bit Functions in Smart Card Interface Mode (when SMIF in SCMR = 1)
Bit Bit Name
7 TIE
6 RIE
5 TE
4 RE
3 MPIE
2 TEIE
1 CKE1
0 CKE0
[Legend]
x: Don't care
Rev. 3.00 Jul. 14, 2005 Page 438 of 986
REJ09B0098-0300
Initial Value R/W
0 R/W
0 R/W
0 R/W
0 R/W
0 R/W
0 R/W
0 R/W
0 R/W
Description
Transmit Interrupt Enable
When this bit is set to 1,a TXI interrupt request is
enabled.
Receive Interrupt Enable
When this bit is set to 1, RXI and ERI interrupt
requests are enabled.
Transmit Enable
When this bit is set to 1, transmission is enabled.
Receive Enable
When this bit is set to 1, reception is enabled.
Multiprocessor Interrupt Enable (enabled only
when the MP bit in SMR is 1 in asynchronous
mode)
Write 0 to this bit in smart card interface mode.
Transmit End Interrupt Enable
Write 0 to this bit in smart card interface mode.
Clock Enable 1, 0
Controls the clock output from the SCK pin. In
GSM mode, clock output can be dynamically
switched. For details, see section 15.7.8, Clock
Output Control.
•
When GM in SMR = 0
00: Output disabled (SCK pin functions as I/O port.)
01: Clock output
1x: Reserved
•
When GM in SMR = 1
00: Output fixed to low
01: Clock output
10: Output fixed to high
11: Clock output