Renesas H8S Series Hardware Manual page 711

Bit Bit Name Initial Value Slave Host Description
3 FLASHE 0
2 HDINIE 0

1, 0 All 0
• LMCCR2
Bit Bit Name Initial Value Slave Host Description
7 FLPIE* 0
6 FLEIE* 0
R/W

R/W Flash Memory Programming/Erasing Enable
Enables/disables to program/erase the flash memory
by the LPC/FW memory cycle. Programming/erasing
the flash memory is controlled in combination with the
FLPIE and FLEIE bits by the flash memory
programming/erasing command.
0: Disables to program/erase the flash memory
1: Enables to program/erase the flash memory

R/W RAM Buffer Initialization Enable
Enables/disables the function which automatically
initializes the 128-byte transfer buffer contents to H'FF.
This bit is valid when the BUFINIIE bit is cleared to 0.
0: Disables to initialize RAM buffer automatically
1: Enables to initialize RAM buffer automatically

R/W Reserved
These bits are read as 0 and cannot be modified.
R/W

R/W Flash Memory Programming Interrupt Enable (LMCI)
0: Disables the flash memory programming command
receive complete interrupt
1: Enables the flash memory programming command
receive complete interrupt

R/W Flash Memory Erasing Interrupt Enable (LMCI)
0: Disables the flash memory erasing command
receive complete interrupt
1: Enables the flash memory erasing command
receive complete interrupt
Section 18 LPC Interface (LPC)
Rev. 3.00 Jul. 14, 2005 Page 663 of 986
REJ09B0098-0300