Port 6 Input Pull-Up Mos; Table 8.5 Port 6 Input Pull-Up Mos States - Renesas H8S Series Hardware Manual

Section 8 I/O Ports
• P60/KIN0/FTCI/TMIX
The function of port 6 pins is switched as shown below according to the P60DDR bit.
When the CKS1 and CKS0 bits in TCR of FRT are both set to 1, this pin can be used as the
FTCI input pin. When the TMIXS bit in PTCNT0 is cleared to 0 and the CCLR1 and CCLR0
bits in TCR of TMR_X are both set to 1, this pin is used as the TMIX(TMRIX) input pin.
When the KMIMR0 bit in KMIMR of the interrupt controller is cleared to 0, this pin can be
used as the KIN0 input pin.
P60DDR
Pin function
8.6.9

Port 6 Input Pull-Up MOS

Port 6 has a built-in input pull-up MOS that can be controlled by software. Port 6 can selects the
current specification for the input pull-up MOSs by the P6PUE bit. When the pin functions as an
output pin of the built-in peripheral function, the input pull-up MOS is always off. Table 8.5
summarizes the input pull-up MOS states.
Table 8.5 Port 6 Input Pull-Up MOS States
Reset
Off
[Legend]
Off: Always off.
On/Off: On when input state and KMPCR = 1; otherwise off.
Rev. 3.00 Jul. 14, 2005 Page 188 of 986
REJ09B0098-0300
0
P60 input pin
KIN0 input pin/FTCI input pin/TMIX input pin
Hardware Standby
Mode
Off
Software Standby
Mode
On/Off
1
P60 output pin
In Other Operations
On/Off