Renesas H8S Series Hardware Manual page 577

Bit Bit Name Initial Value R/W
0 ACKB 0
Note: * Only 0 can be written to clear the flag.
Description
R/W Acknowledge Bit
Stores acknowledge data.
Transmit mode:
[Setting condition]
When 1 is received as the acknowledge bit when ACKE=1
in transmit mode
[Clearing conditions]
•
When 0 is received as the acknowledge bit when
ACKE=1 in transmit mode
•
When 0 is written to the ACKE bit
Receive mode:
0: Returns 0 as acknowledge data after data reception
1: Returns 1 as acknowledge data after data reception
When this bit is read, the value loaded from the bus line
(returned by the receiving device) is read in transmission
(when TRS = 1). In reception (when TRS = 0), the value set
by internal software is read.
When this bit is written, acknowledge data that is returned
after receiving is rewritten regardless of the TRS value. If
the ICSR register bit is written using bit-manipulation
instructions, the acknowledge data should be re-set since
the acknowledge data setting is rewritten by the ACKB bit
reading value.
Write the ACKE bit to 0 to clear the ACKB flag to 0, before
transmission is ended and a stop condition is issued in
master mode, or before transmission is ended and SDA is
released to issue a stop condition by a master device.
2
Section 16 I C Bus Interface (IIC)
Rev. 3.00 Jul. 14, 2005 Page 529 of 986
REJ09B0098-0300