Renesas H8S Series Hardware Manual page 865

16-bit single-chip microcomputer

Hide thumbs Also See for H8S Series:

Table of Contents

• Response, H'06 (one byte): Response to 128-byte programming.

On completion of programming, the boot program will return ACK.

Error Response

• Error response, H'D0 (1 byte): Error response to 128-byte programming

• ERROR (1 byte): Error code

H'11: Checksum error

H'2A: Address error

H'53: Programming error

An error has occurred in programming and programming cannot be continued.

(10) Erasure

Erasure is performed with the erasure selection and block erasure commands.

First, erasure is selected by the erasure selection command and the boot program then erases the

specified block. The command should be repeatedly executed if two or more blocks are to be

erased. Sending a block erasure command from the host with the block number H'FF will stop the

erasure processing. On completion of erasing, the boot program will wait for selection of

programming or erasing.

The sequence for the erasure selection command and block erasure command is shown in figure

Section 21 Flash Memory (0.18-µm F-ZTAT Version)

Rev. 3.00 Jul. 14, 2005 Page 817 of 986

REJ09B0098-0300

H8s/2100 series H8s/2114r R4f2114r