Ping Ipv6 - H3C SR6600 Command Reference Manual

1.1.2.2
1.1.1.2
1.1.1.1
--- 1.1.2.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/11/53 ms
The output shows the following:
The destination was reachable.
•
The route is 1.1.1.1 <-> {1.1.1.2; 1.1.2.1} <-> 1.1.2.2.
•
Table 1 Command output
Field
PING 1.1.2.2
56 data bytes
press CTRL_C to break
Reply from 1.1.2.2 : bytes=56
Sequence=1 ttl=255 time=1 ms
Record Route
--- 1.1.2.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 0/4/20
ms

ping ipv6

Use ping ipv6 to verify whether an IPv6 address is reachable, and display the corresponding statistics.
Syntax
ping ipv6 [ -a source-ipv6 | -c count | -m interval | -s packet-size | -t timeout | -vpn-instance
vpn-instance-name ] * host [ -i interface-type interface-number ]
Description
Test whether the device with IP address 1.1.2.2 is reachable.
Number of data bytes in each ICMP echo request.
During the execution of the command, you can press Ctrl+C to abort the
ping operation.
Received the ICMP reply from the device whose IP address is 1.1.2.2. If
no reply is received during the timeout period, "Request time out" is
displayed.
•
bytes—Number of data bytes in the ICMP reply.
•
Sequence—Packet sequence, used to determine whether a segment is
lost, disordered or repeated.
•
ttl—TTL value in the ICMP reply.
•
time—Response time.
Routers through which the ICMP echo request passed. They are
displayed in inversed order. The router with a smaller distance to the
destination is displayed first.
Statistics on data received and sent in the ping operation.
Number of ICMP echo requests sent.
Number of ICMP echo requests received.
Percentage of packets not responded to the total packets sent.
Minimum/average/maximum response time, in ms. The field is not
available for failed ping attempts in an IPv4 network. In an IPv6 network,
however, the field is available and set to 0/0/0 ms.
5