Display Ipv6 Routing-Table Verbose; Display Ipv6 Relay-Route - H3C MSR 20-20 Command Reference Manual

948 C 71: IP R
HAPTER OUTING

display ipv6 routing-table verbose

Syntax
View
Parameters
Description
Examples

display ipv6 relay-route

Syntax
T C
ABLE OMMANDS
display ipv6 routing-table verbose
Any view
None
Use the
display ipv6 routing-table verbose
information about all active and inactive routes, including the statistics of the
entire routing table and information for each route.
# Display detailed information about all active and inactive routes.
<Sysname> display ipv6 routing-table verbose
Routing Table :
Destinations : 1
Destination : ::1
NextHop : ::1
RelayNextHop : ::
Neighbour : ::
Interface : InLoopBack0
State : Active NoAdv
Tunnel ID : 0x0
Age : 22161sec
Table 211 Description on the fields of the display ipv6 routing-table verbose command
Field
Destination
PrefixLength
Nexthop
Preference
RelayNextHop
Tag
Neighbour
ProcessID
Interface
Protocol
State
Cost
Tunnel ID
Label
Age
display ipv6 relay-route
Routes : 1
Description
Destination IPv6 address
Prefix length of the address
Next hop
Routing preference
Relay next hop
Tag of the route
Neighbor address
Process ID
Outbound interface
Routing protocol
State of the route, Active, Inactive, Adv (advertised), or NoAdv (not
advertised)
Cost of the route
Tunnel ID
Label
Time that has elapsed since the route was generated
command to display detailed
PrefixLength : 128
Preference
Tag
ProcessID
Protocol
Cost
Label
: 0
: 0H
: 0
: Direct
: 0
: NULL