Resetkey; Rta Bind - H3C MSR 20-20 Command Reference Manual

Parameters
Description
Related command:
Example

resetkey

Syntax
View
Parameters
Description
Example

rta bind

Syntax
View
terminal-number: Terminal number, ranging 1 to 255.
Use the
reset rta statistics
display rta.
# Clear all the statistics about terminal 1.
<Sysname> reset rta statistics 1
resetkey ascii-code&<1-3>
undo resetkey
Terminal template view
ascii-code&<1-3>: ASCII value of a hotkey, ranging 1 to 255. "&<1-3>" means
that you can provide up to three ASCII values.
Use the resetkey command to set the terminal reset hotkey.
Use the
undo resetkey
By default, no terminal reset hotkey is configured.
After you press the terminal reset hotkey when a terminal fault occurs, the router
tears down and then reestablishes the TCP connection with the FEP.
Note that the ASCII value of the redrawing hotkey configured must be different
from that of any other hotkey configured on the device. Otherwise, hotkey
conflicts will occur. For example, the hotkey value cannot be set to 17 or 19
because these two values are used for the hotkeys of flow control. Using the
hotkey may not get a response rapidly when the terminal displays too much data.
# Configure the terminal reset hotkey as <Ctrl+A> by setting its ASCII value to 1.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc] resetkey 1
rta bind { mac-address interface interface-type interface-number | string string }
undo rta bind
System view
command to clear the statistics of a terminal.
command to cancel the configured terminal reset hotkey.
913