Sendbuf Bufsize - H3C MSR 20-20 Command Reference Manual

Description
Example

sendbuf bufsize

Syntax
View
Parameters
Description
Example
terminal-number: Terminal number, ranging 1 to 255.
Use the
rta terminal
Use the
undo rta terminal
By default, no template is applied on the interface.
A terminal can be created only after the configured template is applied on the
corresponding interface, so as to implement terminal access. Use the
terminal-number argument to specify the terminal number. An interface can be
connected to only one physical terminal. The router identifies physical terminals by
terminal number.
Note that at least one VTY should be configured in the terminal template for the
template to be applied on the interface. This command supports asynchronous
serial interfaces, synchronous/asynchronous serial interfaces, and AUX interfaces.
This command can be configured on a synchronous/asynchronous serial interface
only when the interface operates in the asynchronous mode.
# Apply the terminal template abc with the terminal number of 1 on the interface.
<Sysname> system-view
[Sysname] interface async 1/1
[Sysname-rta-async1/1] rta terminal abc 1
sendbuf bufsize size
undo sendbuf bufsize
Terminal template view
size: Maximum size of data sent to the terminal at one time, in bytes, ranging 2 to
500.
Use the sendbuf bufsize
sent to the terminal.
Use the
undo sendbuf bufsize
By default, the maximum size of data to be sent to the terminal at one time is 500
byes.
The router sends data in packets to the terminal. The sizes of the sent packets are
different. Use the size argument to specify the maximum data packet size.
# Configure the maximum size of data to be sent at one time as 200 bytes.
command to apply a template on the interface.
command to cancel the template application.
command to configure the maximum size of data to be
command to restore the default.
917