Natpt Address-Group - H3C MSR 20-20 Command Reference Manual

868 C 66: NAT-PT C
HAPTER

natpt address-group

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
<Sysname> display natpt statistics
NATPT Statistics:
Total Sessions:
Expired Sessions:
Hits:
Misses:
Total Fragment Sessions:
Expired Fragment Sessions:
Fragment Hits:
Fragment Misses:
Total Address Mapping:
Total V6Server Mappings:
NATPT Interfaces:
Ethernet1/0
Table 188 Description on fields of the display natpt statistic command
Field
Total Sessions
Expired Session
Hits
Misses
Total Fragment Sessions
Expired Fragment Sessions
Fragment Hits
Fragment Misses
Total Address Mappings
Total V6Server Mappings
NATPT Interfaces: Ethernet1/0
natpt address-group group-number start-ipv4-address end-ipv4-address
undo natpt address-group group-number
System view
group-number: Number of an address pool, in the range of 1 to 31.
start-ipv4-address: Start IPv4 address in a pool.
end-ipv4-address: End IPv4 address in a pool.
Use the
natpt address-group
Use the
undo natpt address-group
address pool.
0
0
0
0
0
0
0
0
0 (static: 0
0
Description
Total number of sessions
Number of expired sessions
Number of successful NAT-PT transactions
Number of failed NAT-PT transactions
Total number of active fragment sessions
Number of expired fragment sessions
Number of successful fragment sessions
Number of failed fragment sessions
Number of static and dynamic mappings
Number of V6Server mappings (address/port
mappings)
NAT-PT enabled interface
command to configure a NAT-PT address pool.
command to remove a specified NAT-PT
dynamic: 0 )