Load-Bandwidth; Reset Load-Sharing - H3C MSR 20-20 Command Reference Manual

950 C 71: IP R
HAPTER OUTING

load-bandwidth

Syntax
View
Parameters
Description
Examples

reset load-sharing

Syntax
View
Parameters
Description
Examples
T C
ABLE OMMANDS
load-bandwidth bandwidth
undo load-bandwidth
Interface view
bandwidth: Specifies the load sharing bandwidth for the interface.
Use the
load-bandwidth
bandwidth of the interface.
Use the
undo load-bandwidth
The load sharing bandwidth of an interface defaults to the physical bandwidth of
the interface.
# Configure the load sharing bandwidth of the interface.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] load-bandwidth 100
reset load-sharing statistics ip address ip-address { mask | mask-length }
reset load-sharing statistics all
User view
ip-address: Destination IP address, in dotted decimal notation.
mask: IP address mask, in dotted decimal notation.
mask-length:IP address mask length, in the range 0 to 32.
Use the
reset load-sharing ip address
non-balanced load sharing. This command clears the load sharing statistics of all
the outbound interfaces corresponding to the destination IP address.
Use the reset load-sharing all
the outbound interfaces of all the forwarding entries.
# Display the statistics of bandwidth-based load sharing.
<Sysname> display load-sharing ip address 10.2.1.0 24
There are/is totally 3 route entry(s) to the same destination network.
Nexthop Packet(s)
10.1.1.2 763851
bandwidth command to specify the load sharing
command to restore the default.
command to clear the statistics of
command to clear the load sharing statistics of
Bandwidth[KB] Flow(s)
100000 0
Interface
Ethernet0/0/0