Display Ipv6 Interface Tunnel - H3C MSR 20-20 Command Reference Manual

display ipv6 interface tunnel

Syntax
View
Parameter
Description
Example
Table 189 Description on fields of the display interface tunnel command
Field
aggregation ID
Tunnel source
destination
Tunnel keepalive disable
Tunnel protocol/transport
GRE key disabled
Checksumming of GRE packets
disabled
Last 300 seconds input
Last 300 seconds output
packets input
input error
packets output
output error
display ipv6 interface tunnel number
Any view
number: Tunnel interface number.
Use the
display ipv6 interface tunnel
information of a specified tunnel interface, including link state, IPv6 protocol state,
and IPv6 address.
# Display information of the interface tunnel 0.
<Sysname> display ipv6 interface tunnel 0
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::101:101
Global unicast address(es):
2002:101:101::1, subnet is 2002::/16
Joined group address(es):
FF02::1:FF01:101
FF02::1:FF00:1
FF02::2
FF02::1
MTU is 1500 bytes
Description
Link aggregation group ID referenced by a tunnel. If
the device supports link aggregation groups, the link
aggregation group ID configured in tunnel interface
view is displayed. If device does not support,
"aggregation ID not set" is displayed.
Source address of a tunnel.
Destination address of a tunnel.
Disables the keepalive function of the GRE so as not to
detect the tunnel interface state.
Tunnel protocol and transport protocol.
No key is configured for the GRE tunnel interface.
Disables the GRE packet checksum function.
Number of bytes and packets input per second in the
last five minutes.
Number of bytes and packets output per second in the
last five minutes.
Total number of input packets.
Number of error packets among all input packets.
Total number of output packets.
Number of error packets in all output packets
command to display related IPv6
883