Display Ipv6 Routing-Table Acl - H3C MSR 20-20 Command Reference Manual

View
Parameters
Description
Examples

display ipv6 routing-table acl

Syntax
View
Parameters
Description
Examples
Any view
None
Use the
display ipv6 routing-table
information, including destination IP address and prefix, protocol type, priority,
metric, next hop and outbound interface.
The command displays only active routes, namely, the brief information about the
current optimal routes.
# Display brief routing table information
<Sysname> display ipv6 routing-table
Routing Table :
Destinations : 1
Destination : ::1/128
NextHop : ::1
Interface : InLoop0
Table 209 Description on the fields of the display ipv6 routing-table command
Field
Destination
NextHop
Preference
Interface
Protocol
Cost
display ipv6 routing-table acl acl6-number [ verbose ]
Any view
acl6-number: Basic IPv6 ACL number, in the range 2000 to 2999.
Verbose: Displays both active and inactive verbose routing information permitted
by the ACL. Without this keyword, only brief active routing information is
displayed.
Use the
display ipv6 routing-table acl
information permitted by the IPv6 ACL.
If the specified IPv6 ACL is not available, all routing information is displayed.
# Display brief routing information permitted by ACL 2000.
<Sysname> display ipv6 routing-table acl 2000
Routes Matched by Access list
command to display brief routing table
Routes : 1
Description
Destination IPv6 address
Next hop
Routing preference
Outbound interface
Routing protocol of the route
Routing cost
command to display routing
2000 :
943
Protocol : Direct
Preference : 0
Cost : 0