H3C MSR 20-20 Command Reference Manual page 933

verbose: Displays detailed routing table information, including that for inactive
routes. With this argument absent, the command displays only brief information
about active routes.
Description Use the
routes permitted by a specified basic ACL.
This command is intended for the follow-up display of routing policies.
For more information about routing policy, refer to "Routing Policy Common
Configuration Commands" on page 1187.
n
If the specified ACL does not exist or it has no rules configured, the entire routing
table is displayed.
Examples # Define basic ACL 2000 and set the route filtering rules.
<Sysname > system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.0.0 0.0.255.255
[Sysname-acl-basic-2000] rule deny source any
# Display brief information about active routes permitted by basic ACL 2000.
[Sysname-acl-basic-2000] display ip routing-table acl 2000
Routes Matched by Access list : 2000
Summary Count : 6
Destination/Mask
10.1.1.0/24
10.1.1.2/32
10.1.2.0/24
10.1.2.1/32
10.1.3.0/24
10.1.3.1/32
For detailed description of the above output, see Table 202.
# Display detailed information about both active and inactive routes permitted by
basic ACL 2000.
<Sysname> display ip routing-table acl 2000 verbose
Routes Matched by Access list : 2000
Summary Count: 6
Destination: 10.1.1.0/24
Protocol: Direct
Preference: 0
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
Destination: 10.1.1.2/32
display ip routing-table acl
Proto
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
NextHop: 10.1.1.2
State: Active Adv
Tag: 0
command to display information about
Pre Cost NextHop
0 10.1.1.2
0 127.0.0.1
0 10.1.2.1
0 127.0.0.1
0 10.1.3.1
0 127.0.0.1
Process ID: 0
Cost: 0
Interface: Vlan1
Neighbour: 0.0.0.0
Label: NULL
Age: 00h25m32s
933
Interface
Vlan1
InLoop0
Eth1/0
InLoop0
Eth1/1
InLoop0