Ipv6 Nd Ra Halt - H3C MSR 20-20 Command Reference Manual

View
Parameter
Description
Example

ipv6 nd ra halt

Syntax
View
Parameter
Description
Example
Interface view
value: Neighbor reachable time in milliseconds, in the range of 1 to 3,600,000.
Use the
ipv6 nd nud reachable-time
reachable time on an interface. This time value serves as not only the neighbor
reachable time on the local interface, but also the value of the Reachable Timer
field in RA messages sent by the local interface.
Use the undo ipv6 nd nud reachable-time
neighbor reachable time and to specify the value of the Reachable Timer field in
RA messages as 0, so that the number of hops is determined by the host itself, but
not specified by the device.
By default, the neighbor reachable time on the local interface is 30,000
milliseconds and the Reachable Timer field in RA messages is 0.
# Set the neighbor reachable time on Ethernet1/0 to 10,000 milliseconds.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ipv6 nd nud reachable-time 10000
ipv6 nd ra halt
undo ipv6 nd ra halt
Interface view
None
Use the ipv6 nd ra halt
Use the
undo ipv6 nd ra halt
By default, RA messages are suppressed.
On a switch
■
# Suppress RA messages on Vlan-interface100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd ra halt
On a router
■
# Suppress RA messages on Ethernet1/0.
command to configure the neighbor
command to restore the default
command to enable RA message suppression.
command to disable the RA message suppression.
853