Ip V 6 Unicast Policy Routing Configuration Commands; Apply Default Output-Interface; Apply Destination-Based-Forwarding - H3C MSR 20-20 Command Reference Manual

69

apply default output-interface

Syntax
View
Parameter
Description
Related command:
Example

apply destination-based-forwarding

Syntax
View
Parameter
IP 6 U
V NICAST
C
ONFIGURATION
apply default output-interface interface-type interface-number
undo apply default output-interface [ interface-type interface-number ]
IPv6 policy-based-route view
interface-type interface-number: Specifies an interface.
Use the
apply default output-interface
interface for IPv6 packets.
Use the
undo apply default output-interface
default outgoing interface.
This command only applies to packets not finding a match in the routing table.
You can specify up to five default outgoing interfaces, implementing load
balancing based on data streams.
apply ipv6-precedence, apply ipv6-address next-hop, apply
output-interface, apply ipv6-address default next-hop.
# Set the default outgoing interface to the interface Serial 2/0.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply default output-interface serial 2/0
apply destination-based-forwarding
undo apply destination-based-forwarding
IPv6 policy-based-route view
None
P R
OLICY OUTING
C
OMMANDS
command to set a default outgoing
command to remove the