Ipv6 Address; Ipv6 Address Auto Link-Local - H3C MSR 20-20 Command Reference Manual

Description
Example

ipv6 address

Syntax
View
Parameter
Description
Example

ipv6 address auto link-local

Syntax
Use the command to enable the IPv6 packet forwarding function.
ipv6
Use the command to disable the IPv6 packet forwarding function.
undo ipv6
By default, the IPv6 packet forwarding function is disabled.
# Enable the IPv6 packet forwarding function.
<Sysname> system-view
[Sysname] ipv6
ipv6 address { ipv6-address prefix-length | ipv6-prefix/prefix-length }
undo ipv6 address [ ipv6-address prefix-length | ipv6-prefix/prefix-length ]
Interface view
ipv6-address: IPv6 address.
ipv6-prefix: Prefix of an IPv6 address.
prefix-length: Prefix length of an IPv6 address, in the range 1 to 128.
Use the ipv6 address
aggregatable global unicast address for an interface.
Use the
undo ipv6 address
interface.
By default, no site-local address or global unicast address is configured for an
interface.
Note that except the link-local address automatically configured and the one
generated through stateless autoconfiguration, all IPv6 addresses will be removed
from the interface if you carry out the undo ipv6 address command without any
parameter specified.
# Set the aggregatable global IPv6 unicast address of Ethernet1/0 to 2001::1/64.
<Sysname> system-view
[Sysname] interface Ethernet1/0
[Sysname-Ethernet1/0] ipv6 address 2001::1/64
ipv6 address auto link-local
undo ipv6 address auto link-local
command to configure an IPv6 site-local address or
command to remove the IPv6 address from the
845