Ipv6 Nd Autoconfig Managed-Address-Flag; Ipv6 Nd Autoconfig Other-Flag - H3C MSR 20-20 Command Reference Manual

850 C 65: IP 6 B
HAPTER V
Parameter
Description

ipv6 nd autoconfig managed-address-flag

Syntax
View
Parameter
Description
Example

ipv6 nd autoconfig other-flag

Syntax
View
Parameter
C C
ASICS ONFIGURATION OMMANDS
mtu-size: Size of the maximum transmission units (MTUs) of an interface in bytes,
in the range of 1,280 to 1,500. The default value is 1,500.
Use the ipv6 mtu
interface.
Use the
undo ipv6 mtu
# Set the MTU of IPv6 packets sent over Ethernet1/0 to 1280 bytes.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ipv6 mtu 1280
ipv6 nd autoconfig managed-address-flag
undo ipv6 nd autoconfig managed-address-flag
Interface view
None
Use the ipv6 nd autoconfig managed-address-flag
managed address configuration (M) flag to 1 so that the host can acquire an IPv6
address through stateful autoconfiguration (for example, DHCP server).
Use the
undo ipv6 nd autoconfig managed-address-flag
restore the M flag to the default value "0" so that the host can acquire an IPv6
address through stateless autoconfiguration.
By default, the M flag is set to 0.
# Configure the host to acquire an IPv6 address through stateful
autoconfiguration.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ipv6 nd autoconfig managed-address-flag
ipv6 nd autoconfig other-flag
undo ipv6 nd autoconfig other-flag
Interface view
None
command to set the MTU of IPv6 packets sent over an
command to restore the default MTU.
command to set the
command to