Him/Mim/Mic Failures; Configuration System Problems; No Terminal Display; Garbled Terminal Display - H3C SR6600-X Series Manual

HIM/MIM/MIC failures

Symptom
When a HIM/MIM/MIC is hot swapped, the output from the configuration terminal shows that the
HIM/MIM/MIC is faulty or the router cannot recognize the HIM/MIM/MIC.
%Jun 14 11:12:36:037 2012 H3C DRVICOUT/1/DrvIcOutStr: -Slot=4;
Card in Slot 4 Sublot 1 can not be recognized !
Solution
To resolve the problem:
1. Verify that the HIM/MIM/MIC is firmly seated.
2. Verify that the HIM/MIM/MIC is correctly inserted into a FIP-210/FIP-600 module. A FIP-110
module does not support HIMs.
3. Verify that the HIM/MIM/MIC connector pins of the FIP module are not bent.
4. If the problem persists, contact H3C Support.

Configuration system problems

If the configuration environment setup is correct, the configuration terminal displays boot information
when the router is powered on. If the setup is incorrect, the configuration terminal displays nothing or
garbled text.

No terminal display

Symptom
The configuration terminal displays nothing when the router is powered on.
Solution
To resolve the problem:
1. Verify that the power supply system is operating correctly and the console cable is correctly
connected.
2. Verify that the console cable is connected to a correct serial port. (The serial port in use must be
the one set on the terminal.)
3. Verify that the console terminal settings are as follows:
Bits per second—9,600.

Data bits—8.

Parity—None.

Stop bits—1.

Flow control—None.

Terminal Emulation—VT100.

4. Verify that the console cable is not faulty.
5. If the problem persists, contact H3C Support.

Garbled terminal display

Symptom
Terminal display is garbled.
73