Display Interface Tunnel - H3C MSR 20-20 Command Reference Manual

882 C 68: T
HAPTER UNNELING

display interface tunnel

Syntax
View
Parameter
Description
Related command:
Example
C C
ONFIGURATION OMMANDS
[Sysname2] interface tunnel 1
[Sysname2-Tunnel1] source 192.100.1.1
[Sysname2-Tunnel1] destination 193.101.1.1
display interface tunnel [ number ]
Any view
number: Tunnel interface number. If the number argument is not specified, the
information of all tunnel interfaces will be displayed.
Use the display interface tunnel
specified tunnel interface, such as source address, destination address, and
encapsulation mode.
interface tunnel, source, destination, and tunnel-protocol.
# Display information of the interface tunnel 0.
<Sysname> display interface tunnel 0
Tunnel0 current state: UP
Line protocol current state: UP
Description: Tunnel0 Interface
The Maximum Transmit Unit is 64000
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, aggregation ID not set
Tunnel source 192.13.2.1, destination 192.13.2.2
Tunnel keepalive disable
Tunnel protocol/transport GRE/IP
GRE key disabled
Checksumming of GRE packets disabled
Last 300 seconds input:
Last 300 seconds output:
361 packets input,
0 input error
361 packets output,
0 output error
Table 189 Description on fields of the display interface tunnel command
Field
Tunnel0 current state: UP
Line protocol current state: UP
Description
Tunnel0 Interface
Maximum Transmit Unit
Encapsulation is TUNNEL
command to display related information of a
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
9953388 bytes
30324 bytes
Description
The physical layer of the tunnel interface is reachable.
The link layer of the tunnel interface is reachable.
Descriptive information of a tunnel interface
Tunnel interface number
Maximum transmission unit (MTU) in a tunnel
The encapsulation protocol is tunnel.