Apply Output-Interface - H3C MSR 20-20 Command Reference Manual

892 C 69: IP 6 U
HAPTER V
Description
Related command:
Example

apply output-interface

Syntax
View
Parameter
Description
Related command:
P R C
NICAST OLICY OUTING ONFIGURATION
Table 191 Preferences and the corresponding keywords
Preference value
4
5
6
7
Use the apply ipv6-precedence
packets.
Use the
undo apply ipv6-precedence
apply output-interface, apply ipv6-address next-hop, apply default
output-interface, apply ipv6-address default next-hop.
# Set a preference of 5 (critical) for matched IPv6 packets.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply ipv6-precedence critical
apply output-interface interface-type interface-number
undo apply output-interface [ interface-type interface-number ]
IPv6 policy-based-route view
interface-type interface-number: Specifies an interface.
Use the
apply output-interface
matched IPv6 packets.
Use the
undo apply output-interface
interface.
Note that:
Five outgoing interfaces at most can be specified, and load balancing based on
■
data streams can be implemented.
For non-P2P interfaces (broadcast and NBMA interfaces) such as Ethernet
■
interface, multiple next hops are available, and thus packets may not be
forwarded successfully.
apply ipv6-precedence, apply ipv6-address next-hop, apply default
output-interface, apply ipv6-address default next-hop.
C
OMMANDS
Keyword
flash-override
critical
internet
network
command to set a preference for matched IPv6
command to remove the preference.
command to set an outgoing interface for
command to remove the outgoing