Mtu - H3C MSR 20-20 Command Reference Manual

View
Parameter
Description
Related command:
Example

mtu

Syntax
View
Parameter
Description
Example
undo interface tunnel number
System view
number: Tunnel interface number, in the range of 0 to 1023. The number of
tunnels that can be created is restricted by the total number of interfaces and the
memory.
Use the
interface tunnel
interface view.
Use the undo interface tunnel
interface.
By default, there is no tunnel interface on the device.
Carry out the interface tunnel command to enter interface view of a specified
■
tunnel. If the tunnel interface is not created, you must create it before entering
tunnel interface view.
A tunnel interface number has only local significance, and therefore, the same
■
interface number or different interface numbers can be set at both ends of a
tunnel.
display interface tunnel, source, destination, and tunnel-protocol.
# Create the interface tunnel 3.
<Sysname> system-view
[Sysname] interface tunnel 3
[Sysname-Tunnel3]
mtu mtu-size
undo mtu
Tunnel interface view
mtu-size: Tunnel interface MTU in bytes, in the range of 100 to 64,000.
Use the command to configure the tunnel interface MTU.
mtu
Use the command to restore the default tunnel interface MTU.
undo mtu
The default value varies with devices.
# Set the tunnel interface MTU to 10,000 bytes.
command to create a tunnel interface and enter tunnel
command to remove a specified tunnel
885