Menu Hotkey; Menu Screencode - H3C MSR 20-20 Command Reference Manual

908 C 70: T
HAPTER ERMINAL

menu hotkey

Syntax
View
Parameters
Description
Related command:
Example

menu screencode

Syntax
View
A C C
CCESS ONFIGURATION OMMANDS
menu hotkey ascii-code&<1-3>
undo menu hotkey
Terminal template view
ascii-code&<1-3>: ASCII value of hotkey, ranging 1 to 255. "&<1-3>" means that
you can provide up to three hotkey ASCII values.
Use the
menu hotkey
Use the
undo menu hotkey
By default, no menu hotkey is configured.
If the current terminal operates on the service interface, you can switch to the
menu interface by entering the menu hotkey configured.
RTC terminal access does not support the menu function.
Note:
The ASCII value of the hotkey must be different from that of any other hotkey
■
configured on the device. Otherwise, hotkey conflicts will occur. For example,
the hotkey value cannot be set to 17 or 19 because these two values are used
for the hotkeys of flow control.
Using the hotkey may not get a response rapidly when the terminal displays
■
too much data.
Before using this command, make sure you enable the router to print
■
characters to the terminal and enable menu printing.
print information and print menu.
# Configure the hotkey for switching to the menu as <Alt+A>, whose
corresponding ASCII codes are a combination of 1, 96, and 13.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc] menu hotkey 1 96 13
menu screencode string
undo menu screencode
Terminal template view
command to configure the menu hotkey.
command to cancel the menu hotkey configured.