Print Connection-Info - H3C MSR 20-20 Command Reference Manual

Parameters
Description
Example

print connection-info

Syntax
View
Parameters
Description
string: Screen code of the terminal, containing 1 to 15 case-insensitive characters.
Use the
menu screencode
Use the screencode command to remove the menu screen code.
undo menu
By default, no such a screen code is configured.
Some types of terminals provide the screen saving function. When such a terminal
receives a specific screen code, such as E!10Q (for details about screen codes, refer
to the related terminal manuals), it saves the current interface and switch to the
corresponding screen.
Note that this function requires terminal support and the screen code configured
on the router and that specified on the terminal must be the same. Screen codes
vary with terminal types. For details, refer to the corresponding terminal manuals.
For example, Start terminals support E!8Q, E!9Q, E!10Q, E!11Q, E!12Q, and
E!13Q.
# Configure a menu screencode of E!10Q.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc]menu screencode E!10Q
print connection-info
undo print connection-info
Terminal template view
None
Use the
print connection-info
connection information on the terminal.
Use the
undo print connection-info
terminal connection information.
By default, terminal connection information is printed on the terminal.
To facilitate your operation, after a TCP connection is established between the
terminal and the FEP, the terminal will display a message indicating that the
connection is successful. To disable the prompt message from being displayed, use
the undo print connection-info command.
Make sure you enable the router to print characters on the terminal before using
this command.
command to configure a menu screen code.
command to enable the printing of terminal
command to disable the printing of
909