Jumboframe Enable - H3C VSR Series Command Reference Manual

Predefined user roles
network-admin
Parameters
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
interface-number.subnumber: Specifies a subinterface number. The interface-number argument is an
interface number. The subnumber argument is the number of a subinterface created under the interface.
The value range for the subnumber argument is 1 to 8192.
Usage guidelines
When the interface-number.subnumber argument is specified, and the specified subinterface does not
exist, this command creates the subinterface and enters subinterface view.
Examples
# Enter GigabitEthernet 1/0/1 interface view.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1]
# Create Layer 3 Ethernet subinterface GigabitEthernet 1/0/1.1 and enter GigabitEthernet 1/0/1.1
subinterface view.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1.1
[Sysname-GigabitEthernet1/0/1.1]

jumboframe enable

Use jumboframe enable to allow jumbo frames within the specified length to pass through.
Use undo jumboframe enable to prevent jumbo frames from passing through.
Syntax
jumboframe enable [ value ]
undo jumboframe enable
Default
The device allows jumbo frames within a specific length to pass through. The length of jumbo frames that
are allowed to pass through varies by virtual NIC type.
Views
Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
value: Sets the maximum length (in bytes) of Ethernet frames that are allowed to pass through. The value
range and default value for this argument vary by virtual platform type and virtual NIC type.
22