H3C MSR 20-20 Command Reference Manual page 659

Description
Related command:
Example
Use the
display interface mfr
the existing MFR interfaces. If you do not provide an MFR interface number, this
command will display the state information about all the existing MFR interfaces.
interface mfr.
# View the state information about MFR 2.
<Sysname> display interface mfr 2
MFR2 current state: DOWN
Line protocol current state: DOWN
Description: MFR2 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet protocol processing : disabled
Link layer protocol is FR IETF
LMI DLCI is 0, LMI type is Q.933a, frame relay DTE
LMI status enquiry sent 0, LMI status received 0
LMI status timeout 0, LMI message discarded 0
Physical is MFR
Output queue : (Urgent queue : Size/Length/Discards)
Output queue : (Protocol queue : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Table 118 Description on the fields of the display interface mfr command
Field
current state
Line protocol current state
Description
The Maximum Transmit Unit
Internet protocol processing
Link layer protocol
LMI DLCI
LMI type
frame relay
LMI status enquiry sent 0, LMI status
received 0
LMI status timeout 0, LMI message
discarded 0
Physical
command to view the state information about
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
Description
Physical state of the interface: UP/DOWN
State of the link layer protocol: UP/DOWN
Description string of the interface
Maximum transmit unit (MTU) of the interface
Processing state of the network layer protocol:
enabled/disabled
Link layer protocol
Data link connection identifier (DLCI) used by the local
management interface (LMI)
Type of the LMI
Type of the frame relay device
Statistics on packets sent/received over the link layer
Physical type of the interface
659
0/50/0
0/75/0