Ip Unicast Policy Routing Configuration Commands; Apply Default Output-Interface; Apply Ip-Address Default Next-Hop - H3C MSR 20-20 Command Reference Manual

61

apply default output-interface

Syntax
View
Parameters
Description
Related commands:
Examples

apply ip-address default next-hop

Syntax
View
IP U
NICAST
C
ONFIGURATION
apply default output-interface interface-type interface-number [ track
track-entry-number ] [ interface-type interface-number [ track track-entry-number ] ]
undo apply default output-interface [ interface-type interface-number
[ interface-type interface-number ] ]
policy-based-route view
interface-type interface-number: Specifies an interface.
track track-entry-number: Specifies a track entry. The track-entry-number is in the
range 1 to 1024.
Use the
apply default output-interface
interface for matched packets.
Use the
undo apply default output-interface
configuration.
Using this command can set two outgoing interfaces at most for load-sharing.
apply ip-precedence, apply ip-address next-hop, apply output-interface,
and apply ip-address default next-hop.
# Set the default outgoing interface for matched packets to Serial2/0.
<Sysname> system-view
[Sysname] policy-based-route aa permit node 11
[Sysname-policy-based-route] apply default output-interface serial 2
/0 track 1
apply ip-address default next-hop ip-address [ track track-entry-number ]
[ ip-address [ track track-entry-number ] ]
undo apply ip-address default next-hop [ ip-address [ ip-address ] ]
policy-based-route view
P R
OLICY OUTING
C
OMMANDS
command to set the default outgoing
command to remove the