Display Virtual-Access - H3C MSR 20-20 Command Reference Manual

664 C 44: L
HAPTER OGICAL

display virtual-access

Syntax
View
Parameter
Description
Example
I C
NTERFACE ONFIGURATION
Table 120 Description of the fields of the display mfr command
Field
Bundle name = MFR0
Bundle links
Serial1/0, PHY state = up, link
state = up, Link name = Serial1/0
display virtual-access [ dialer dialer-number | vt vt-number | user user-name | peer
peer-address | va-number ]*
Any view
dialer-number: Dialer interface number, ranging from 0 to 1023.
vt-number: Number of the VT where the virtual access (VA) interface resides. This
argument ranges from 0 to 1023.
user-name: Name of the user accessing through the VA interface. This argument is
a string of 1 character to 80 characters.
peer-address: Peer IP address of the VA interface, in dotted decimal notation.
va-number: Sequence number of the VA interface, ranging from 0 to 128.
Use the
display virtual-access
the VA interfaces.
n
When necessary, the system will automatically create VA interfaces, which will
adopt the parameters defined in a specific VT. You need not create and configure
VA interfaces manually. VA interfaces will be removed due to underlying layer
disconnection or user intervention.
# View the state information about all the VA interfaces.
<Sysname> display virtual-access vt 1
Virtual-Template1:0 current state :UP
Line protocol current state :UP
Description : Virtual-Template1:0 Interface
The Maximum Transmit Unit is 1500
Link layer protocol is PPP
LCP opened, MP opened, IPCP opened, OSICP opened
Physical is MP, baudrate: 64000
Output queue : (Urgent queue : Size/Length/Discards)
Output queue : (Protocol queue : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
C
OMMANDS
Description
Name of the MFR bundling
Physical interface information on each bundled link
Physical interface of the bundled link, physical state of the
interface, state of the link layer, and the name of the
bundled link (name of the corresponding interface by
default)
command to view the state information about
0 bytes/sec 0 packets/sec
0 bytes/sec 0 packets/sec
0/50/0
0/75/0