Ip Count Timeout; Reset Ip Count - H3C MSR 20-20 Command Reference Manual

Example

ip count timeout

Syntax
View
Parameter
Description
Example

reset ip count

Syntax
If a firewall is configured on an interface and incoming and outgoing IP packets
■
are denied by the firewall, these IP packets are counted in the firewall-denied
table.
If the source or destination IP address of the IP packets passing the interface (in
■
this case, a firewall may be configured or not) matches a network address in
the rule, the packets are counted in the interior table. Otherwise, the packets
are counted in the exterior table.
Note that:
You can configure up to 32 rules.
■
If no rule is configured, the current packets are not concerned and are all
■
counted in the exterior table.
# Create an IP accounting rule.
<Sysname> system-view
[Sysname] ip count rule 169.254.10.1 255.255.0.0
ip count timeout minutes
undo ip count timeout
System view
minutes: Aging time in minutes for an accounting entry, in the range of 60 to
10,080.
Use the
ip count timeout
accounting entry.
Use the
undo ip count timeout
By default, the aging time for an accounting entry is 720 minutes, namely, 12
hours.
If an accounting entry is not updated before its aging time expires, the entry is
considered expired and then deleted.
# Set the aging time for an IP accounting entry to 100 minutes.
<Sysname> system-view
[Sysname] ip count timeout 100
reset ip count { all | exterior | firewall | interior }
command to configure aging time for an IP
command to restore the default.
779