Oap Enable - H3C CR16000-F Manual

Views
System view
Predefined user roles
network-admin
Parameters
client-id : Specifies an OAP client by its ID in the range of 1 to 255. Client IDs are assigned by
the OAP manager to OAP clients to uniquely identify the clients.
Usage guidelines
When you execute this command for a client in registered state, the OAP manager sends a restart
notification to the specified OAP client. The client restarts after receiving the notification. When you
execute this command for a non-existent client, an error message appears.
Examples
# Restart OAP client 1.
<Sysname> system-view
[Sysname] oap client reboot 1
Related commands
display oap client summary
oap client close

oap enable

Use oap enable to enable OAP.
Use undo oap enable to disable OAP.
Syntax
oap enable
undo oap enable
Default
OAP is disabled on an interface.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Layer 3 Ethernet interface view
Layer 3 aggregate interface view
Predefined user roles
network-admin
Examples
# Enable OAP on interface GigabitEthernet 3/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] oap enable
4