654
C
42: P
I
HAPTER
ORT
SOLATION
Description
Example
C
C
ONFIGURATION
OMMANDS
Use the
port-isolate enable
isolation group (Group 1) as an ordinary port.
Use the
undo port-isolate enable
isolation group.
Configured in Ethernet interface view, the setting is effective on the current port
only; configured in port group view, the setting is effective on all ports in the port
group.
Refer to "Link Aggregation Configuration Commands" on page 473 for
information about port groups.
This command adds a port to the default isolation group 1.
# Add port Ethernet 1/0 to isolation group 1.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] port-isolate enable
command to add the current port to the default
command to remove the port from the