Bootp Client Configuration Commands; Display Bootp Client - H3C MSR 20-20 Command Reference Manual

55

display bootp client

Syntax
View
Parameter
Description
Example
BOOTP C
C
OMMANDS
n
BOOTP client configuration can only be used on Layer 3 Ethernet interfaces
■
(including sub-interfaces) and VLAN interfaces.
If several VLAN interfaces sharing the same MAC address obtain IP addresses
■
through a BOOTP relay agent, the BOOTP server cannot be a Windows 2000
Server or Windows 2003 Server.
You are not recommended to enable both the DHCP client and the DHCP
■
Snooping on the same device. Otherwise, DHCP Snooping entries may fail to
be generated, or the BOOTP client may fail to obtain an IP address.
c
CAUTION: The support for the DHCP Snooping function varies with devices.
display bootp client [ interface interface-type interface-number ]
Any view
interface interface-type interface-number: Displays the BOOTP client information
of the interface.
Use the
display bootp client
BOOTP client.
Note:
If interface interface-type interface-number is not specified, the command will
■
display information about BOOTP clients on all interfaces.
If interface interface-type interface-number is specified, the command will
■
display information about the BOOTP client on the specified interface.
# Display related information about the BOOTP client on Ethernet1/0.
<Sysname> display bootp client interface ethernet 1/0
Ethernet1/0 BOOTP client information:
Allocated IP: 169.254.0.2 255.255.0.0
Transaction ID = 0x3d8a7431
Mac Address
C
LIENT
command to display related information about a
00e0-fc0a-c3ef
ONFIGURATION