Irf Auto-Merge Enable - H3C MSR 810 Command Reference Manual

Welcome to use easy IRF.
To skip the current step, enter a dot sign (.).
To return to the previous step, enter a minus sign (-).
To use the default value (enclosed in []) for each parameter, press Enter without
entering a value.
To quit the setup procedure, press CTRL+C.
*****************************************************************************
Select a member by its ID <2> [2]:2
Specify a new member ID <1~10> [1]: 1
Specify a domain ID <0~4294967295> [0]: 10
Specify a priority <1~32> [1]: 10
Specify IRF-port 1 bindings (a physical interface or a comma-separated physical
interface list)[Disabled]: ten-gigabitethernet2/0/1,ten-gigabitethernet2/0/2
Specify IRF-port 2 bindings (a physical interface or a comma-separated physical
interface list)[Disabled]:
*****************************************************************************
IRF new member ID: 1
IRF domain ID
IRF priority
IRF-port 1
IRF-port 2
*****************************************************************************
Are you sure to use these settings to set up IRF? [Y/N] y
Starting to configure IRF...
Configuration succeeded.
The device will reboot for the new member ID to take effect. Continue? [Y/N] y

irf auto-merge enable

Use
irf auto-merge enable
Use
undo irf auto-merge enable
Syntax
irf auto-merge enable
undo irf auto-merge enable
Default
IRF auto-merge is enabled. The IRF fabric that has failed in the master election reboots
automatically to complete the IRF fabric merge.
Views
System view
Predefined user roles
network-admin
Usage guidelines
If the IRF auto-merge feature is disabled, you must follow the system instructions to manually reboot
member devices in the IRF fabric that fails master election.
Configuration summary for member 2
: 10
: 10
: Ten-GigabitEthernet2/0/1, Ten-GigabitEthernet2/0/2
: Disabled
to enable IRF auto-merge.
to disable IRF auto-merge.
12