Connecting the AP to a power source
You can supply power to the AP by using a local power source or through PoE as required. Before
powering the AP, make sure the local power source or the power sourcing equipment (PSE) is
reliably grounded.
Connecting a PoE power source
To power the AP through PoE, use an Ethernet cable to connect an Ethernet port on a PoE switch to
the GE port on the AP.
Connecting a local power source
You can use an AC/DC power adapter to connect the AP to a local power source. No power adapter
is provided with the AP. Purchase a power adapter from H3C as required.
power adapter specifications.
Table 2 Power adapter specifications
Item
Input
Output
Figure 24 Using a power adapter to connect the AP to a local power source
Check after power-on
Examine the LEDs on the AP after you power on it to verify that the AP is operating correctly. For
more information about the LEDs, see ports and LEDs in Hardware Information and Specifications.
Specification
100 VAC to 240 VAC
+48 VDC to +55 VDC
10
Table 2
describes the