Ip Count Exterior-Threshold; Ip Count Firewall-Denied - H3C MSR 20-20 Command Reference Manual

Example

ip count exterior-threshold

Syntax
View
Parameter
Description
Example

ip count firewall-denied

Syntax
View
# Enable IP accounting.
<Sysname> system-view
[Sysname] ip count enable
ip count exterior-threshold number
undo ip count exterior-threshold
System view
number: Maximum number of accounting entries in the exterior table, in the
range of 0 to 8,192.
Use the
ip count exterior-threshold
number of accounting entries in the exterior table.
Use the
undo ip count exterior-threshold
When doing this, you are prompted to clear the table first if any accounting
entries already exist in the table.
By default, the maximum number of accounting entries in the exterior table is 0.
Rule-incompliant packets are not to be counted.
IP packets are sorted as follows:
If a firewall is configured on an interface and incoming and outgoing IP packets
■
are denied by the firewall, these IP packets are counted in the firewall-denied
table.
If the source or destination IP address of the IP packets passing the interface (in
■
this case, a firewall may be configured or not) matches a network address in
the IP accounting rule, the packets are recorded in the interior table.
Otherwise, the packets are counted in the exterior table.
# Set the maximum number of accounting entries in the exterior table to 100.
<Sysname> system-view
[Sysname] ip count exterior-threshold 100
ip count firewall-denied { inbound-packets | outbound-packets }
undo ip count firewall-denied { inbound-packets | outbound-packets }
Interface view
command to configure the maximum
command to restore the default.
775