Dynamic; Standby Routing-Group; Standby Routing-Rule - H3C MSR 20-20 Command Reference Manual

43

standby routing-group

Syntax
View
Parameter
Description
Example

standby routing-rule

Syntax
View
Parameter
D
YNAMIC
C
ONFIGURATION
n
Refer to "DCC Configuration Commands" on page 315 for more information
about dial control center (DCC).
standby routing-group group-number
undo standby routing-group group-number
Interface view
group-number: Dynamic route backup group number, ranging from 1 to 255.
Use the standby routing-group
function on a dialup interface.
Use the undo standby routing-group
backup function.
By default, the dynamic route backup function is disabled.
n
Before enabling the dynamic route backup function on a dialup interface, make
sure that DCC has been enabled on the dialup interface.
# Enable the dynamic route backup function on Bri 3/0.
<Sysname> system-view
[Sysname] interface bri 3/0
[Sysname-Bri3/0] standby routing-group 1
standby routing-rule group-number ip ip-address { mask | mask-length }
undo standby routing-rule group-number [ ip ip-address { mask | mask-length } ]
System view
group-number: Dynamic route backup group number, ranging from 1 to 255.
R B
OUTE ACKUP
C
OMMANDS
command to enable the dynamic route backup
command to disable the dynamic route